Technisat TechniCorder ISIO STC Uživatelský manuál Strana 56

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 64
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 55
56
Fault Possible cause Solution
Receiver cannot be
operated, switched on or off
Defective data stream -->
receiver blocked
Hold down the On/Stand-by
button on the receiver or the
remote control for approx.
5 seconds.
Pull the mains plug out
of the power supply for
approx. 5 seconds and then
switch the deviceback on
Perform a Flash reset:
Warning!
All personal settings will be
lost.
> Remove the mains adap-
ter from the device
> Press and hold
Standby and the up
arrow key at the same
time.
> With Standby and
the up arrow key
depressed, reconnect
the plug
> Keep the buttons
pressed for around
5 seconds and then
release both buttons.
The text “Factory set-
tings” appears in the
display.
USB device not recognised USB device formatted for
wrong file system
Format USB device for
FAT32 file format
Device automatically
switches off after a certain
time
Auto Standby function is
activated
Auto Standby setting-check
and deactivateif necessary.
(section 8.2.7)
Zobrazit stránku 55
1 2 ... 51 52 53 54 55 56 57 58 59 60 61 62 63 64

Komentáře k této Příručce

Žádné komentáře