Technisat TechniStar S2 Uživatelský manuál stáhnout pdf (Strana 42)

Error Possible cause Solution

Receiver cannot be

operated, switched on or

switched off.

Defective data stream -->

receiver blocked.

Hold down the On/Stand-by

button on the receiver or

on the remote control for

approx. 5 seconds.

Disconnect mains plug for

approx. 5 seconds, then

reconnect receiver.

Perform Flash Reset:

Warning!

All personal settings will be

lost.

> Remove DC plug from

receiver.

> Press and hold the

Standby and up arrow

key at the same time.

> Reinsert DC plug in the

DC socket while holding

down the Standby and

up arrow buttons.

> Keep both buttons

pressed down for

approx. 5 sec. then

release. “SEt” appears

in the display.

USB device not recognised. USB device formatted for

wrong file system.

Format USB device for

FAT32 file format.

42

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48

Komentáře k této Příručce

Žádné komentáře